Well I got all the results in and wing B won by 1 vote over wing C so I might have to a bit of both. Jetpack 2 won hands down so while that is good it will take a bit of creative thinking as I think it will be a pig to cast lol.
Anyway I got a little test work done on a wing B yesterday lunch time as it looked like it was a contender and was easier to cut out than wing C.
I got hold of some 1mm thick plasticard and found that is ideal for the main wing section but it becomes too thick when I put the wing frames on so now I can.
A: stick it on and sand it down
B: try my hand and some green stuff on there
C: etch the frame pattern on the wing
D: but the frame out of 2mm thick plasticard and stick them together.
I might have a little go at all of them and see how it works out
Here is the progress shots from yesterday lunchtime
And a little progress update from today as well
Wing C is just imposable to cut out (at work anyway) at this scale with the tools I have to hand but could try bringing in my pin vice drill.
I have tried hand sculpting the wing frame wiht some green stuff and that has turned out ok so might to that way for the moment until I hit another potential snag lol
will let it cure before i trim it down a bit and sand it flatter as well as sorting out the other side